Hardware
4.2.2
Power Supplies
The system default configuration is to get the 15V, 3.3V and 3.3V analog rail voltages
from the PFC stage board. However, it is also possible to use an external 24V power
supply to generate these voltages.
U19, C70, C73, C71 and C74 regulate the voltage applied to the system via J15 (28V
max). The output of the regulator is connected to the system through R109. The circuit
Note:
It is the responsibility of the user to populate these components if an
external power supply is used.
U18, C67, R110, C68, D16, D15, L3, R111, R112 and C75 regulate the 15 volts to cre-
ate a 3.3V digital rail. This auxiliary 3.3V digital rail is applied to the system through
R106. The circuit is shown in Appendix A. “Board Layout and Schematics” .
Note:
It is the responsibility of the user to populate these components if an
external power supply is used.
R114, R107, C69, and C72 form a decoupling circuit for generating a 3.3V rail for the
analog circuitry such as the ADC reference and the current feedback reference. This
auxiliary 3.3V analog rail is applied to the system through R108.
Note:
4.2.3
It is the responsibility of the user to populate these components if an
external power supply is used.
Power Module
The three-phase inverter is embedded in a power module (U16). This power module
contains:
?
?
?
?
?
?
?
?
?
?
600V/30A 3-phase IGBT Inverter Bridge
Gate driver circuitry for each IGBT
Three Independent connections to the negative DC bus for current sensing
Short-circuit protection circuitry
Thermal Shutdown
Gate Driver Power Supply Undervoltage protection
Gate Driver Power Supply Overvoltage protection
Single-grounded power supply
Isolation of 2.5 kV per minute
Maximum switching frequency: 20 kHz
The dsPIC DSC provides the PWM signals to this power module in order to turn on/off
the IGBT, and therefore apply power to the motor phases.
R95 sets the threshold limit for the overcurrent circuitry. If this voltage is greater than
0.5 V (typical), a fault signal is asserted and the low-side IGTBs are turned off. R94 and
C53 form a low-pass RC filter that filters out the frequencies above 88.4 kHz.
C56 sets the fault pulse duration, the value of C56 is given by the following equation:
C56 = 18.3E-6 x 1.8E-3 seconds. Therefore, the fault pulse duration is 54 μs
The power module fault output pin (VFO) is open-collector configured. R50 pulls up the
fault output to the analog 3.3V rail. R53 and C40 form a low-pass RC filter that filters
out the frequencies above 53 kHz.
For more information about this power module please refer to the manufacturer ’s data
sheet.
? 2009 Microchip Technology Inc.
DS70605A-page 37
相关PDF资料
DMA-MC-XP-N2 IP CORE MCDMA CTLR XPGA ISPXPGA
DN-5002C N-WAY ETHERNET SWITCH 8-PORT
DN-7006GS WIRELESS LAN PCI ADAPTER
DN-7020 WIFI FINDER W/DISPLAY WLAN ADAPT
DN-93501-U/BL CONN JCK RJ45 TOOL FREE CAT5E BK
DN-93501-U/B CONN JCK RJ45 TOOL FREE CAT5E BU
DN-93501-U/R CONN JCK RJ45 TOOL FREE CAT5E RD
DN-93501-U/WH CONN JCK RJ45 TOOL FREE CAT5E WT
相关代理商/技术参数
DM330023 制造商:Microchip Technology Inc 功能描述:dsPICDEM MCHV Development Board
DM330023-2 功能描述:电源管理IC开发工具 dsPICDE MCHV-2 RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V
DM-330-C 制造商:Greenlee Textron Inc 功能描述:DMM 1000V 10A RMS
DM3312X101R (2500 REEL) 制造商:Laird Technologies Inc 功能描述:IND CHIP BEAD 100OHM 100MHZ 10A - Tape and Reel
DM3312X101R-00 功能描述:FERRITE ULTRA HC 100 OHMS SMT RoHS:否 类别:滤波器 >> 铁氧体磁珠和芯片 系列:- 标准包装:1,000 系列:EMI1812 频率对应阻抗:120 欧姆 @ 100MHz 额定电流:200mA DC 电阻(DCR):最大 400 毫欧 滤波器类型:差模 - 单线 封装/外壳:1812(4532 公制) 安装类型:表面贴装 包装:带卷 (TR) 高度(最大):0.069"(1.75mm) 尺寸/尺寸:0.177" L x 0.126" W(4.50mm x 3.20mm) 其它名称:Q1712807A
DM3312X101R-10 功能描述:电磁干扰滤波珠子、扼流圈和阵列 100ohms 100MHz RoHS:否 制造商:AVX 阻抗: 最大直流电流:35 mA 最大直流电阻: 容差: 端接类型:SMD/SMT 电压额定值:25 V 工作温度范围:- 25 C to + 85 C 封装 / 箱体:0603 (1608 metric)
DM-333 制造商:Labfacility Limited 功能描述:SENSOR PT100 THIN FILM 2X10MM CL B 制造商:LABFACILITY 功能描述:SENSOR, PT100, THIN FILM, 2X10MM, CL B 制造商:LABFACILITY 功能描述:SENSOR, PT100, THIN FILM, 2X10MM, CL B; Sensing Temperature Min:-50C; Sensing Temperature Max:+600C; Approval Bodies:IEC; Approval Category:Class B; External Length / Height:10mm; External Width:2mm; Measuring Range:-50C to ;RoHS Compliant: Yes
DM-334 制造商:Labfacility Limited 功能描述:SENSOR PT100 THIN FILM 2X10MM CL A 制造商:Labfacility Limited 功能描述:SENSOR, PT100, THIN FILM, 2X10MM, CL A 制造商:Labfacility Limited 功能描述:SENSOR, PT100, THIN FILM, 2X10MM, CL A, Lead Length:10mm, Sensing Temperature Mi 制造商:Labfacility Limited 功能描述:SENSOR, PT100, THIN FILM, 2X10MM, CL A, Lead Length:10mm, Sensing Temperature Min:-50C, Sensing Temperature Max:+400C, Approval Bodies:IEC, Approval Category:Class A, External Length / Height:10mm, External Width:2mm, Material:Thin, RoHS Compliant: Yes